Ok I installed the cap kit on my monitor...it did absolutly nothing. What a waste of time. Anyway after doing some research online and asking around on the Arcade Museum forums I got a few suggestions.
1.) Replace Resistor R360. (R360 is a 27ohm Resistor, mine was reading 37.4ohms)
2.) Adjust L351 until a decent image comes in.
3.) Fine tune the image using the Horizonal Hold.
I did all three and here's where I'm at with the image.
It's getting there, at least I can see the entire image...mostly. However the left side of the screen looks like it has down's and the whole image is way to far up the screen...I'm lost, I've spent hours on this thing trying to get the image to look right, it just isn't happening...any ideas?
